compressive force造句
例句与造句
- Axial compressive force
轴向压力 - This sensor is especially suited to the measurement of static and quasi - static compressive forces
这个型号的传感器特别适合于测量静态或准静态压缩力。 - Experimental research on stability parameters for i - section aluminium alloy bars loaded by axial compressive force
工字形铝合金轴心压杆稳定系数的试验研究 - Dies for presses for pressure connections ; mechanical presses with a nominal compressive force up to 15 and up to 60 kn connecting ; dimensions
压力连接件用压力机模具.标称压力15kn和60kn以下的机 - Dies for presses for pressure connections ; hydraulical presses with a nominal compressive force up to 300 , up to 450 and up to 1000 kn connecting ; dimensions
压力连接件用压力机模具.标称压力为300 450和1000k - It's difficult to find compressive force in a sentence. 用compressive force造句挺难的
- Cancellous allografts can be obtained in a demineralized form that increases osteogenic potential but greatly decreases resistance to compressive forces
同种异体松质骨进行脱钙处理后成骨性能得到加强，但压力抵抗会大大降低。 - Therefore the upper layer is water flow and the nether layer is debris flow . the moving water compressive force and the shear force of interface are taken into account
将粘性泥石流与主河的汇流视为分层流研究，上层为主河水流模型，下层为水下泥石流运动模型。 - It ideally meets the needs of these fields , being available in measuring ranges from 0 . 50 kg up to 0 . 5000 kg , suitable for both tensile and compressive force measurements
它非常符合这些领域的测量要求，可以测量0 . 50 kg最大0 . 5000 kg ，还适合于拉力和压缩力的测量。 - At the same time , pulsating compressive force due to the crust movement including earthquake also made the crystallized rock ruptured and form ore control fault fracture and the host fracture
残浆的形成与排出，控矿构造的发生、发展与控矿过程，都是在这次地壳运动过程中完成的。 - Its test specimens are four hollow shear wall of reinforced concrete , which have the different the ratio of shear span to effective depth of section and the ratio of axial compressive force to axial compressive ultimate capacity of section
本课题为钢筋混凝土空心剪力墙抗震试验研究及非线性有限元分析，课题的对象为四片不同轴压比以及不同剪跨比的钢筋混凝土空心剪力墙板。 - However , at present the heavy rammer method is still used to determine the standard of compactness and molding specimen by still compressive force in laboratory testing . which leads to the inconsistency of compaction mode between field compaction and laboratory compaction
但作为现场施工指导的室内试验，依然采用击实法确定压实度标准，静力压实法成型试件，导致室内试验的压实方式和现场压实状况不一致。 - In static test , t - shaped and l - shaped specimens were respectively divided into four groups according to concrete strength grades , sectional height to thickness ratio , reinforcement ratio and ratio of axial compressive force to axial compressive ultimate capacity of section . how these factors affect the load - carrying and deformation of short - leg shear wall is known by analysis the result
在拟静力试验中对t形和l形短肢剪力墙分别进行了四组试验，通过对试验结果的分析，揭示了混凝土等级、截面配筋率、轴压比和墙肢截面高厚比等因素对短肢剪力墙承载力和变形的影响。 - The frequency of concrete strength testing is determined by the quantity of concrete used for a structure . a pre - cast mould is filled with concrete and , upon curing , soaked in water for 28 days before delivering to a laboratory for the " crushing " test . the compressive force needed to break the concrete represents the strength of the concrete
在建筑过程中，建造商要按地盘中使用石屎数量的多寡，去?定测试石屎强度的次数，测试时建造商需要在预制的铸模内倒满石屎，待它凝固后浸在水里二十八日，再运往实验室进行测试，看看需要用几大的力量才能把它压碎，这个令石屎碎裂的力度就是石屎的强度。 - The frequency of concrete strength testing is determined by the quantity of concrete used for a structure . a pre - cast mould is filled with concrete and , upon curing , soaked in water for 28 days before delivering to a laboratory for the " crushing " test . the compressive force needed to break the concrete represents the strength of the concrete
在建筑过程中，建造商要按地盘中使用石屎数量的多寡，去定测试石屎强度的次数，测试时建造商需要在预制的铸模内倒满石屎，待它凝固后浸在水里二十八日，再运往实验室进行测试，看看需要用几大的力量才能把它压碎，这个令石屎碎裂的力度就是石屎的强度。 - A two component design consisting of appropriate size and length of structural reinforcing rods and dead - end component is required to transfer axial tensile loads and distribute radial compressive forces through the plastic jacket and onto the internal strength members without damaging the fragile plastic jacket or internal optical fibers
螺旋预绞丝结构不仅能有效地降低配合区域内光缆单位应力和避免应力集中，传递轴向张力，而且将预绞丝的径向压力均匀地分布在这段较长的配合区域内。
更多例句： 下一页